Review on 🔌 Proxxon Thermocut 37080 Wire Cutter by Deandre Vogt

Nice little knife. I think it just needs a slightly heavier wire as it will bend unless I move REALLY slowly. Also, I would advise them to add some small holes for the diameter pins to be inserted. Using a pencil with tape didn't work very well so I drilled a few small holes in the table and inserted some wire. Much better but it would be nice if they were pre-drilled as we don't really know what's under the table and they could probably make it more accurate. almost immediately. You can then pull back, although sometimes the foam will stick to the wire, so just toggle it on/off quickly to loosen it. The edge guide is also not as stiff as I would hope. When cutting a large number of strips, I supported the guide so it wouldn't move as much. Tighten knobs well to avoid loosening and check frequently.