Review on π Maximize Fluid Control with Control Devices Brass Check Valve by Neil Bodell
This valve will fail
Used as a check valve for a 3/4 compressor after around 6-8 months of compressor operation continued to turn off the circuit breaker. Eventually the valve was found to be defective, the plastic end you see in the picture was sticking out of the hole about 1/4 inch or so which somehow caused the check valve not to close to keep pressure in the line for to let the next compressor start, not to let the pistons go and the fuse blown. I'm lucky I didn't damage the compressor.
- Can be used as a reservoir check valve for small compressors or as a component of pneumatic circuits
- Not as thick as other picks
New products
Comments (0)
Top products in π§ Fittings
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
