Review on 🔊 Enhance Your Creality Printers with 3Dman Stepper Vibration Technology by Lawrence Crespo

I would like to rate the dampers separately from the rest of the kit. So far I have an X-Stepper and a Y-Stepper on my CR-10 S5. I have no idea how hard the E and 2x Z will work, I'll find out another time. The shock absorbers took a lot of noise out of the engines. The audio is now much softer in volume and pitch of the hum. The printer is in the attic in the central part of my house before it was even audible in the garage. Now I'm sitting next to it, and other than high-speed fill passes, I can't hear any X or Y movement at all on my desktop fan (65dB). If I set a lower speed limit in the slicer, I might not hear it at all. Radiators aren't great. Some of them flexed in transit, not enough to affect their performance but enough to be noticed. The included M3 screws are Phillips rather than hex, and there's no thermal grease or sticky pads to attach the large suction cups to the stepper motors. Seems like a minor oversight, but it actually decreases the ease of installation of this kit.