Review on 👑 Revolutionary Kingroon Photocuring Monochrome Printing: Precision and Quality Redefined by Will Anderson

I've been using FDM printers for about three years and recently wanted to try an SLA printer to improve print quality on smaller models. I bought it because it was a small printer that seemed like a good introduction to SLA printing, and I was right! Setting up the printer itself was incredibly easy, and following the instructions in the manual I printed my first mockup the same day. The models came out incredibly clean and there were no imperfections at all which, as this was my first attempt, I was pleasantly surprised! I'm still learning the differences between FDM and SLA, but this was a great first machine and I plan to use it with my other printers all the time! The only two problems I had initially was setting up the software, not knowing that the configuration files and slicer came with the printer, so I tried setting it up manually. Once I realized everything was on a flash drive, the installation went smoother than ever. Getting used to the software is another issue that confused me a bit, but after a few minutes using Cura became very similar. Overall very happy with this printer!