Review on 🚽 Moen DN0708CH Pivoting Toilet Holder: The Ultimate Bathroom Storage Solution by Eric Weber

I bought two of these holders to replace the single sided TP holders. The reels kept falling out of the one-sided L-shaped ones and it was easy to rip them off the wall as my kids kept playing with them like they were a joystick! The style of these Moens was exactly what I wanted. Also, the simple TP loading approach seemed like a good idea. So off I went. I've read reviews that the template is about 1/4 inch off. (Many, many) Thanks to everyone who mentioned this. I made provisions to position the drill point at about 1/4". In fact, I sort of did by eye. Look at the picture of my template, which shows where I drilled a set of holes (in a circle , not in the middle, which was about 1/4" less than full width). After installing it, I downloaded the Charmin Mega Roll to see how it would fit. It touches the round base of the two Ends. But not too bad. The TP rolls out easily without having to pull. See fig. Two thumbs up! Only four stars because the template is a little different. I would like to give it 4.5 stars :) I'm glad that I bought two. Tomorrow I'll take another bathroom. I wish there was a way to lightly tighten the set screws on the bottom with the Allen key that comes with the package. With a narrow space at the bottom and an angle, do this slowly by 50 at a time -60 degrees By the way, I don't have the shitty ones Used anchors that came with the kit. I have purchased several metal solid wall anchors and am very happy with them. They worked like a charm and I highly recommend them.