Review on ✂️ Enhance Precision Cutting with Lnchett Nibbler Quality Attachment Straight by Issac Smart

I thought that the body of the Kenmore dryer was made of fairly thick sheet metal. I thought it was a lot thicker than the max size 16 gauge lnchett nibbler. I pulled the knife out of the box to admire the workmanship. It looked very good. Installed it in my drill bit and figured I'd just bite off about 1/4 inch and see where it slots in. Trigger pulled, bit off about 1/2 inch and stopped. It wasn't loud and it wasn't difficult. So I pulled the trigger and cut a hole about 4 inches in diameter in the side of my wife's dryer like I had done many times before. Turns in sheet metal easily and with a lot of control. It's really very easy to use and comes with extra heads and a tool for changing heads and minor repairs by the user. This kit also comes with a step drill so it's pretty complete. The most important feature is that it is safe and not very intimidating. Cons: I bought this tool because I needed to cut a duct hole in the side of my wife's dryer and that was it! Cutting tool with very early forced withdrawal. Since I'm a rat with tools, I'll never sell it. Did I tell you about the cool case it comes in?