Review on 🔴 KeylessOption Red Remote Control Key Fob Replacement - 4 Button Keyless Entry by Jerry Chembola

These remotes worked as advertised and they came with bonus batteries pre-installed which saved me the trip to the store. Please note that the instructions for your vehicle may differ. I used them for an expedition and needed to use the F250 truck process, not the one documented for the expedition. I'm not sure if that applies to everyone, but in my case it was. If following the Expedition supplier's instructions does not work for you, do the following: 1. Close all doors, then open the driver's door and press the unlock button on the driver's door while it is open.2. Within 10 seconds, cycle the ignition from OFF to RUN 8 times, ending with RUN on the 8th time. The door locks will lock and unlock to confirm you have entered programming mode (Off is the position where you can remove the key, "Run" is the position where you can hardly start the car. When the door locks don't work, try again.but faster.If they still won't start, your car may not have keyless entry)3. Within 8 seconds, press any button on the first keyless remote to be programmed. The door locks will be cycled through to confirm the programming. If you only have one remote control, skip to step 5.4. Press any button on the second keyless remote within 8 seconds. The door locks will click again to confirm the programming. Repeat step 4. for all other remote controls.5. Turn off the ignition. The locks switch again, indicating the end of the programming mode. Works great as advertised and saved me from the dealer. What's not to like?