Review on Ultimate Paint Protection: 3M Scotchgard Clear Bulk Film Roll 12-by-60 inches by Steven Bush

The instructions below are taken from the Clear Mask website. They also have kits and how-to videos. I don't work for them (haha) but the sheer bra came with no instructions and I found this site helpful. Suggested Tools and Materials • Soft mop for attachment • 1 liter spray bottles (Qty: 2) • Baby shampoo • 70% isopropyl alcohol • Scratch resistant cloth for details CLEAN BRA PUTTING INSTRUCTIONS: 1. Surface must be clean and free of wax, grease, insects etc. and between 55ºF and 90ºF. Thoroughly clean the surface with alcohol solution.2. Wash your hands thoroughly and keep your fingers wet as they come into contact with the adhesive side of the material from time to time and wet fingers will not stick to the material or leave marks.3. Check the part position, shape and size before installation.4. Spray the solution on the surface of the car.5. Peel back the backing to reveal the adhesive. Spray with solution. Place the transparent bra on the vehicle. As long as there is a solution under the protective sheet, it can be moved. CAUTION: Do not use too much solution! 6. Spray the solution over the protective film to prevent the squeegee from sticking or scratching the film. Starting from the center, remove the solution and bubbles. Block the squeegee passages to avoid leaving bubbles under the material.7. For indentations or complex curves, re-wet the adhesive and again slowly squeeze with a squeegee with firm pressure. The material stretches a little. Some parts need stretching to get the right fit and conform to the contour of the curves.8. If an edge is raised or won't stay down, spray a solution of 20% isopropyl alcohol and 50% water and wipe the edge with a lint-free paper towel. The towel absorbs the liquid and the material adheres to the painted surface. Sometimes if you give the edge a few minutes to dry it will stay in place. SLIP SOLUTION: 32 OZ SPRAYER: 3 DROPS JOHNSON & JOHNSON BABY SHAMPOO! !