Review on Revolutionize Your Printing Experience with the Instone Inventor Printer Touchscreen Enclosed by Christopher Smith

CONS: I would give it 4.5 stars because there are a few small things I would like to improve. Be careful with fragile filament as it will most likely break when the device returns to its original position during the print cycle. The filament spool is undersized for most common filament spool sizes, but works great with instone filament. PROS: Setup was easy. The printer prints amazingly well with minimum retraction speed, temperature and travel speed settings. I printed in .2 and .1 sizes and the layers look amazing. Loading the filament is easy. I've only printed with PLA and although I use a platform heater I haven't had any warping on parts close to the platform size. Sometimes I had edge curls but no physical parts. I tried using the included craft glue but my UHU stick worked much better. I have nothing good to say about this printer. I feel like I got my money's worth when I bought it for $599. I would normally recommend a DIY printer as a first printer, but if you're just looking to get started this printer is great. Eventually I will try ABS but PTFE in the thermal break will limit my use. I can't wait to see what else these guys come up with.