Header banner
Revain logoHome Page
Josel Lambert photo
1 Level
787 Review
37 Karma

Review on ๐Ÿ”ง MPA2019 Magigoo Nylon Printing Adhesive for Enhanced Results by Josel Lambert

Revainrating 5 out of 5

Helps a lot with gluing nylon

This material is quite expensive for what it is, but does a great job of keeping your nylon casts on the bed. Nylon doesn't like to stick to glass in general but with the Magigoo PA I haven't had any issues with either the Taulmann 910 or the trim line, in fact the 910 stuck so well I thought I'd break my bed if I removed it. This also works for multiple prints - it's not just about the print itself. I gave up my garolite/phenolic bed in favor of glass + this is for nylon prints.

Pros
  • Industry & Science
Cons
  • Little Stuff