That's the solution! I ordered another connector but it sucked so I ended up going with this one, the connectors are much better, should last forever. My problem: 2012 mazda6 has scanning problems. My solution: disconnect the car battery, cut off the old scanner connector to strip the wires. One can simply melt and peel off the insulation with a lighter, expose the wire, use heat shrink tubing and twist them all together, aligning each wire with its pin position as a guide. Just make sure you secure the cable to the car with three zip ties so it doesn't pull on the connectors. The car now has a working obd2 connector so it can pass emissions 👍
Autel AP200H OBD2 Scanner Dongle - Wireless Bluetooth Code Reader with Health Status Reports - Diagnostic Tool for Engine, Transmission, ABS, SRS - OLS/BMS Resets - All Vehicles (Android/iOS)
11 Review
Vgate ICar Pro Bluetooth 3.0 OBD2 Code Reader | Scan Tool For Torque Android To Check Engine Light & Car Faults
19 Review
Precision Bike Torque Wrench Set for Mountain & Road Bikes - Pro Bike Tool 1/4-Inch Drive with Allen & Torx Sockets, Extension Bar, Dual Readout, and Storage Box
11 Review
Upgrade Your Car Diagnostics With 16 Pin OBD2 Extension Cable Splitter - Male To Dual Female Y Cable - 50CM
17 Review
DVR 70MAI Dash Cam Pro Plus+, black (A500S), black
87 Review
Reversible Mi 16-in-1 Ratchet Screwdriver
21 Review
Bit and socket set Stels Tool set, 1/2", 1/4", CrV, plastic case 94 pcs, Stels, 94 pcs, black
46 Review
Rechargeable screwdriver OA-3,6F (433.0.2.00), 3.6 V, 1.3 Ah Li-ion, blister
46 Review