Review on 2-Pc Tap Wrench Set: 1/16"-1/4" & 1/4"-1/2", Perfect For Tapping, Threading, Drilling And Lathe Work by Robert Fulce

The one I received was complete garbage. The jaws were misaligned and one was protruding out about 1/8 inch further than the other one and no matter how much oiling, cleaning, and finessing I did, I could not make this thing work. Even with a smaller tap (M7) in the end and tightening the jaws down good, the tap was crooked in the holder due to the misaligned jaws. And even with the jaws as tight as I could get them, the tap still wiggled a little bit just from using my fingers to try and rock it side by side. I understand that this is not supposed to be a high quality item and it's only 20 bucks but honestly, I would not pay 2 dollars for this piece of garbage. Very disappointed with this item.