Review on Socket Organizer Tray Set for Toolboxes - 6PCS Red SAE & Black Metric Socket Storage Trays, Deep and Shadow Socket Holders for 1/4-Inch, 3/8-Inch & 1/2-Inch Drive by Hector Watkins

These trays work great. They are on the board in my workshop. Drives are 1/4", 3/8", 1/2" in SAE and metric. They take up quite a bit of space, but that's due to the size of the sockets - you just can't make them any smaller. Very nice , just reach out and grab the socket I need and if I'm wrong just plug it back in and grab the one next to it because it's hanging on a perforated board it's hard to read the size but I do Anyway, look for the eye and not the numbers on the sockets however these organizers have the size printed on the top of the pins for you and they are easy to read one thing you should know the sockets come with these boards from Side faces the drive out and not down like most sockets.This keeps the sockets in place as they don't dangle as much at the bottom.If you put the socket on the wrong pin you'll know too.because it doesn't fit properly The sockets pass They're good enough that I can hang them vertically from a pegboard, and they won't fall off even if I remove the outlet next to them. They also stay on when I take the whole organizer off the hanger to take it somewhere else. I've had several outlet organizers over the years and haven't been entirely happy with any of them, but with this one I've finally found one that I'm happy with.