Review on 📷 KeeYees Camera Development Board with 2MP OV2640 Camera Module, WiFi, Bluetooth, 4M PSRAM, Dual-core 32-bit CPU, FT232RL FTDI USB to TTL Serial Converter, and 40-pin Jumper Wire by Bishop Terry

Once I was able to upload the sketch it worked as advertised. Yes, I had trouble uploading the sketch. I followed the advice given in another Daedalus review and it still didn't work. I just got a message that the sketch could not be uploaded. Then it dawned on me that I use Arduinos and ESP. -01 which use the CH340 chip and the programmer that comes with this kit uses an FTDI chip, I downloaded and installed the FTDI drivers and it worked fine. If you need this driver, go to the FTDI website and click "D2XXX Driver" to download the required driver (Windows 10 users select "Install binaries" in the comments section). The first image is directly after programming without focus adjustment, set to 1024 x 768 and cloudy white balance selected. The second image is 800 x 600 and the video was captured with ContaCam.