Header banner
Revain logoHome Page
Wagner Witlin photo
1 Level
1390 Review
54 Karma

Review on ๐Ÿ–จ๏ธ Original Creality Printer Platform 4-Pack by Wagner Witlin

Revainrating 3 out of 5

Description is wrong! Not suitable for Cr-10V3

Cr-10V3 comes with 8-bit motherboard. Open the CR Touch manual and it says only 32-bit motherboard. I decided to try it on my Ender 3 Pro. If you have experience compiling firmware, the installation is quite easy. I think most people are not like that. It took several days of tweaking to get the perfect first layer. I also use a glass bed and it's very flat. The probe rattles in the housing, which is quite unpleasant. After using it for a few days, I noticed that the light was blinking red in the middle of longer prints. I suspect it might have something to do with the probe rattling? To be honest I'm not even 100% sure if it works well or if my bed is just perfectly flat lol! I've never seen the slightest adjustment in the Z axis while printing. I'll give it another week before deciding if it's useful enough to keep. But I tend to say no.

Pros
  • Industrial & Scientific
Cons
  • Some small things