🖨️ Original Creality Printer Platform 4-Pack Review

Advantages: sturdy red wheels; silicone seals; Holds up great with just the M420 S1 for oj. Cons: Was a bit difficult to level but doable. So far they're working great. Was on a printer I just built. It took a while to level the bed, even with octoprint's bed leveling visualizer; But now I set it and forgot about it. I fingered the bed multiple times after each print, multiple prints, and it has stayed that way. I've been typing over 8 hours a day for a week using gcode M420 S1 instead of G29…

You need to remove the magnetic surface to mount the glass platform. The magnetic part is held with glue, so it's a bit difficult to remove, but these clips are much better than binding clips. by simply turning in place. Turns out my magnetic surface was actually glued to the screw heads so my screws just floated free when removed. While fiddling with bed alignment, you can do all four of the following at once: tighter springs, nylon nuts, double glazing, these clips.

Cr-10V3 comes with 8-bit motherboard. Open the CR Touch manual and it says only 32-bit motherboard. I decided to try it on my Ender 3 Pro. If you have experience compiling firmware, the installation is quite easy. I think most people are not like that. It took several days of tweaking to get the perfect first layer. I also use a glass bed and it's very flat. The probe rattles in the housing, which is quite unpleasant. After using it for a few days, I noticed that the light was blinking red in…