Review on 🔦 Araca BL-FP240G /SP.7AZ01GC01 Original Projector Lamp Bulb - Compatible with OPTOMA HD143X, DH350, WU334, WU335, WU336, WU337, EH334, EH335, HD144X, HD270e, HD27e, HD243X by Dustin Gabrielle

Updated July 2021: The company told me they thought I bought the wrong bulb. They refunded my purchase and allowed me to keep my existing lightbulb. .- - - -- - - -- -- --- - -I bought this lamp for Optoma Hd28dse. The apron/lamp trim didn't seem to want to fit into the space easily, which I didn't feel comfortable applying for. To assemble it I had to remove the shroud and replace it with a shroud from the original bulb. Once I did it seemed to fit right in. It was a bit easier that the screws for the replacement cover matched the original. Then it's time to connect the lamp to the projector via the pigtail. Again, the braid didn't seem to fit or snap properly. Also, there was no discernible notch or groove to indicate proper orientation/ensure you didn't plug it in backwards. Again, I had to remove the pigtail from the original lamp and replace the pigtail with this one. It took some care to make sure I had the right connector on the right post. Once that was done I was able to put the bulb back into the case and carefully reattach it, making sure the wires were connected properly. The whole process took less than an hour, so it wasn't too bad, but I also consider myself fairly nimble, willing and able to figure out simple wiring and such. After installing the light bulb, the projector lit up and two weeks later the picture was beautiful, bright and colorful.