Header banner
Revain logoHome Page
Jack Bhowmik photo
1 Level
762 Review
71 Karma

Review on ๐Ÿ”ฅ High Temperature 3D Printer T-K500 m3 x 15mm K Type Thermocouple Sensor - Compatible with Volcano V6 HOTEND Block for 500โ„ƒ PEI PEEK 3D Printing by Jack Bhowmik

Revainrating 5 out of 5

Good quality but look out for the full stainless steel mesh

5 stars for price and quality. I've been using this thermocouple for a while and it's reliable. And the stainless steel mesh feels comfortable. But my extruder has a connector on the carriage with a separate wire harness that runs between the carriage and the control board, so the entire length of this braided wire is looped tightly and attached to my hot end, because the stainless steel sleeve makes any changes in length a serious effort . . I can't dock a product for this, but I'm not sure a stainless steel braid the full length of the wire is a huge feature. Stainless steel for the first 5cm or something might be more efficient.

Pros
  • Best
Cons
  • Ugly packaging