
The device works, but there are many problems. The micro USB port does not work at all. I could not connect the device via the port like comparable ublox boards can. I had the FTDI module and was able to connect the device to the U-Center BUT there is no Sram/EEPROM on this board so you cannot save a configuration. The default value is 57600 baud, 1 cycle per second. If it works for you it should work, but I need to be able to change the configuration.

Bundle: Bracket 3 Cup Set & 6 FT Power Cord for Beltronics & Escort Radar Detectors (Accessory Bundle)
34 Review

Smart Column Yandex New Station Mini - smart column with Alice (with watch), black onyx
432 Review

StarTech.Com HDMI To VGA Cable – 6Ft 2M - 1080P – Active Conversion – HDMI To VGA Adapter Cable For Your VGA Monitor / Display (HD2VGAMM6)
38 Review

💨 LEMOISTAR USB Car Fan, Powerful 4-Speed Wind Circulation Fan for Vehicles SUV RV, Rear Seat Cooling Fan with Durable Hook - 5V USB Powered
38 Review

🎧 Alpha Pilot Headset Flight Bag (Black) – Streamlined Flyer Solution
8 Review

✈️ Enhance Your Aviation Experience with the David Clark H10-13.4 Aviation Headset
9 Review

🗺️ CARRVAS GPS Navigation System for Car, 2021 MAP 7inch Truck GPS Navigation, Spoken Turn-by-Turn Directions, Speed Warning, USA, Canada, Mexico, Lifetime Maps Update
9 Review

🛩️ Stratux ADS-B Dual Band Receiver: Advanced Aviation Weather and Traffic System with WAAS GPS, AHRS, Battery Pack, Suction Mount, Antennas, SDR
9 Review