Review on Motion Pro Fill Air Chuck by Randy Albright

I'm another motorcyclist who is fed up with inflating motorcycle tires with a standard angled air liner. I ride a 2016 Yamaha FZ-07 with stock alloy wheels. I have a standard small angled air sleeve, but because it has to be pressed against the valve at an angle, my hand and even the air line is pressing against my bike's brake rotors and rear drive sprocket. I was really hesitant to get it. Expensive and lots of bad reviews. But I took my chance and so far it's working great! My dad was kind enough to donate a nipple to attach to this cartridge as it is not included. When I attached the fitting and connected it to the air compressor, the cartridge vented air through the valve hole. My dad just put his finger on the valve pin and the cartridge has been airtight ever since. Inflating my bike tires is now much easier! I used to be afraid of it because when I check my tires I'm already dressed for the ride and can't wait to get going. This cartridge made it much easier to inflate and move tires quickly. May I recommend it? I really can't give a concrete "yes" or "no" here. I don't think anyone will argue that this cartridge is really expensive. Of course, this is noticeable, but given the many bad reviews, the quality of this cartridge seems very doubtful. I got a cork in my rear tire from a nasty puncture last year and the cork leaks a little after the bike sits idle for a few days, which is common. While this cartridge made it easier to properly inflate my rear tire, I could have spent $31 on a new rear tire. If you are tired of using traditional pneumatic chucks to inflate your tires, this chuck will make your life easier. Just hope you get a good one!