Review on 🔧 Efficient E-flite Gear Puller: 1mm-5mm Shaft for Easy Component Removal, EFLA212 by Zach Sornsin

The clamp plate was too thick to fit between the gear and the top of the motor I had (shaft diameter 3.17mm). It took a lot of grinding, making him too weak to survive. The levers holding the cam plate extend beyond the cam plate and also interfere with the output bearing protrusion at the front of the motor housing. For the right motor that would be great, but check the clearances. The V-shaped part of the cam is 2 mm thick. The thickness of the milled end of the cam is 1mm, but it is only suitable for 6mm diameter gears. The arms hang 1.6mm below the bottom of the cam plate and have 11mm clearance between them to fit the output bearing.