Review on 🏡 Rockever Outdoor Cat Shelter: Rainproof Outside Kitty House with Escape Door - Protecting Your Feline Friend by Travion Woods

My house was in very good condition when it arrived with a small tear that will easily be patched. The paint turned out very well and the manufacturer was quick to answer my questions about the repair and offered parts if I wanted them. They were very open to suggestions and corrections. Corrected the previous review about short screws fixing the roof, my house came with long screws. I decided to insulate the roof with Home Depot foam board, which is easy to cut with a kitchen knife. We collect wood glue, plug the holes, weatherproof and seal from the outside. We are keeping this home under the porch eaves until they improve the design so it can withstand rain entering through the top porch entrance, in line with my comment to the manufacturer as follows: I want to thank whoever made this smart home designed. However, here are some practical tips that are not criticisms of this beautiful design, but are based on a lot of experience keeping cats outside in snow and rain. This house needs to be under a canopy to really be protected from the rain, but it would be nice to design it so that it can really be outside. Я думаю, что идея сделать его доступным для уборки, сняв полы вместо крыши, была хорошей идеей, но она не работает по этой причине: дождевая вода попадет на верхнюю внешнюю полку крыльца и скатится в верхний этаж, мочить подстилку для домашних животных независимо от того , What do you do. It helps if you put a low barrier like a 1" or 2" sill in a doorway. The cat can still cross it to get in. As the top floor slides out, there are gaps for high winds to penetrate. Then no. No matter what, I still think the best thing would be to make the attic airtight and allow the house to be accessed through the roof. A deep lid and a grommet or gasket that goes into the house like a cork. You can secure it with a finger tight wing nut for easy removal. Then just make the bottom so that you can lift it to access the enclosed lower tier. Also, I prefer the cut hole for the upper tier near the window side of the house since each cat bed needs to be pushed against the wall opposite that Window so the cat can look outside. There is an entrance hole in the floor opposite the window making a hole where a cat bed is needed. about to be, and leaves him unsupported and closes the hole. As planned now, the hole for access must be left open, which means the cat will have to snuggle up to the window to sleep and it will be more difficult to keep an eye on predators. I figured I could just flip the bottom panel to change its direction, but since there's a small notch and staples, it won't work unless I do a little construction work. However, I see the logic your designer used because the current design separates the outside opening from the access opening at the top, providing protection from direct wind or approaching predators. My idea will cause any wind blowing in the bottom door to move up more easily if you use my idea to move the opening closer to the side of the window. So the alternative would be to leave the design as is and move the window itself to the opposite solid wall. This would be great but would require the house to be placed with a solid backing against your house for anchoring and would reduce the ability to support the cat house by its side to the structure. That would be fine with me since the cat house sticks out to the sides instead of to the side, but some people might prefer it for its flatter profile. And finally, it would be nice to make a small hole in the corner of the bottom. Board for access to the external heater connector. Most of us want it to be waterproof and insulated for outdoor use. You can see how I bought insulation boards to cut the roof's internal insulation. This thick panel also solves the problem of a long gap along the inside line of the deck roof allowing the passage of wind. It would be nice to insulate the whole house. In fact, I would be willing to pay more if this work was already offered in a luxury model. Thank you for a great product, that you are so open to suggestions for improvement and also implement them.