Review on Hobart 770476 7018 Stick Welding 🛠️ Rod, 3/32-10 lb.: Superior Performance for Metal Fabrication by Michael Ward

I ordered them and at first I thought they were too thin but in the end they turned out to be very good for my metal 2-6mm thick. Keep them warm in an oven at around 100C and make sure the positive and negative leads are positioned correctly and they start better and give you a better weld. I used around 100A for 2.5mm and up and then around 30-60A. depending on the position thinner. When you stop with the pole, I just tap a non-conductive surface like cement or a non-critical piece of metal to reignite the spark (don't tap too hard or you'll shatter the screen. But you work). much better than the 7016s sold in local shops here.