🔧 Ultimate Precision: VISE GRIP Diagonal Cutting Pliers 2078306 - The Perfect Tool for Accurate Cuts Review

Pros: No Cons: No spring, drilled for one but not there, they cannot be operated with one hand. Looks like a factory wedding. Side cutters also have no edges and are completely blunt, and blunt cutters are useless if you have them, they are useless. Conclusion: request a refund on the day of arrival, needle nose pliers are the same, junk. Don't waste your time and money.

A pair of the two I ordered fails to cut at all and barely strips the wire, edges are totally misaligned and will not connect to the blades , but tend to have an overbite, making them more of a forceps than scissors. I chose these because I like the Irwin in general and thought I'd spend a few bucks more to get a good pair, but unfortunately it didn't work out.

I love these babies l. I've had a bigger day working on something and I couldn't get bigger pieces where I was working. Then he came to me, let's see if it's less than once. To my relief, they were. For greatness they sting. They are able to cut through a range of materials without damaging the cutting edge. I like that the grips are insulated and it gives me peace of mind. You did it again with Visa Snap.

Sharp, smooth, well aligned ==> clean, easy cuts. Enough weight to give the impression that they will last a long time; but not difficult handles are short. Whether you have a wide hand or a long hand, you will be affected. If you get a lot of cuts on a regular basis, this may not be for you. Since I usually do 1 to 1 dozen cuts, they work great for me. I left "Longevity" unrated because I didn't use it enough to form an objective opinion. Based on the "feel", my age and usage patterns, I'm…

Received my knives today and tried them out. I'm happy with them so far. Last weekend I had to replace the bath blower motor and splice and glue the wires. My $3.00 pair of RF cutters didn't cut the electrical tape when I finished wrapping it. They left almost no traces in the feed. When I pulled on the tape to tear it off the roll, it stretched a lot before breaking. I decided I needed a better pair. After reviewing all my options on Amazon. I decided to order these Irwin Cutters. I liked them

These things are comfortable to hold but cut like they've never been sharpened. I have a pair of 25+ year old tailors that went through hell and came back with me and I've decided to get a new pair. I bought this Revain 6" tool along with an 8" tool (same brand) so I had 2 tools to replace one. The other pair cut well enough, but these 6-inch models are rubbish. I can't cut zip ties, network cables, or pretty much anything else I've tried. Great couple and also my 25 year old tailor no problem.

I bought these to cut very strong 80 Nichrome wire and while they don't quite flush they cut perfectly. Knowing where to cut allows me to use them to make a cut prior to installation so there isn't an excessive protrusion over the build deck on my vape. If you want an absolutely flush cut, you'll need to find another pair. If you're vaping kanthal wire, any regular cheap washes will do, but if you're vaping something stronger like stainless steel or NI-80 and don't want to spend money on…