Review on 💡 Enhance Your Lighting Setup with SUPERNIGHT 10 Pack 4 Pin LED Connectors for Waterproof 10mm RGB 5050 LED Strip Lights - Quick and Convenient Strip to Wire Connection! by Alex Tilden

available I saw some people had trouble with this so it worked for me. I use them for the back of my TV so I needed 4 separate strips connected together. Those are silicone coated waterproof strips and those connectors turned out to be the right ones. The easiest way I've found is to cut into strips. Take 1 strip, fold back the backing paper, open the connector 90 degrees and insert the strip into the connector. Make sure it fits into the rounded side of the connector. Then I cut small strips of 4 wires. I found it easier to get these wires into the connector by splitting them about 2 inches and then opening the connector 90 degrees again. Disconnect and close the cable. This part was tricky as I didn't want to use pliers to close the connector and risk breaking it so I used my fingers but the trick is to make sure it's fully closed and you'll hear a little click should when it is closed. Then repeat well and connect the next strip. It took me a while to get this right and I wish there was an easy way to open the ports back up to check the connection. The rest worked great.