Review on OEMTOOLS 27012 Industrial Double Flaring by Edwin Kreps
Not suitable for 3/16 steel lines or possibly other steel lines
Actual 3/16 brake lines on an old Datsun Z 1978 release. Even so, the tool does not have enough power to make even acceptable bells on steel pipe. None of my other hand tools worked either. You will either need a hydraulic flaring tool or buy a complete line with the correct fittings and add enough elbows to get the final length correct. This will probably be fine with copper or some other softer material. For me it was a waste - even though it says steel.
- For use on 4.75mm to 10mm diameter tubing
- Line is shorter than other picks
New products
Comments (0)
Top products in 🔧 Brake Tools
🚗 Motive Products 0100 European Power Brake Bleeder Kit - Efficient Brake System Maintenance for European Vehicles
9 Review
🔧 Adjustable Engine Cylinder Hone Tool - EWK 1-1/4 to 3-1/2 Inch 3 Stones, Deburring Piston Honer with 220 Grit
9 Review
Universal Car Ratcheting Caliper Piston Tool with 2 Steel Plates - Brake Caliper Press (Red, Two Size)
9 Review
🔧 BMC Universal Vacuum Pump: Handheld Brake Bleeder Kit Ensuring Efficient Auto Service & Food Canning with Brake Bleeding Tester Set
9 Review
