Review on 🌀 DEEPCOOL FH-10 High-Performance Integrated Fan Hub, Supports 10 Fans (3-pin Non-PWM or 4-pin PWM), Requires Only One 4-pin Motherboard Header by Kenny Stephens

What to complain about? It works out. I have a 360mm Cooler Master AIO that only comes with 3 fans. The OEM design uses a 1-3 splitter. So you connect one end to the "cpu_fan" header on the motherboard and the other end accepts all 3 fans. Well, I wanted a push-pull, but I was concerned about the motherboard's ability to power 6 fans from a single motherboard port. So here comes this handy little device. I connect one side to my motherboard's cpu_fan header and then all 6 fans are connected to this unit. All 6 fans are getting the right power and running at the right speed that I chose. Since it's a 10-port fan hub, I was even able to connect top rear and bottom fans to it, 9 fans in total, all running at the same exact speed depending on CPU temperature. As the load increases, all fans accelerate to the same speed, which is ideal for me. It works out. The sticky backing is great too. I accidentally put it somewhere without thinking. I ended up having to remove the tape to move it. It was damn hard to remove but even after removing there was still enough adhesive to put it back on. its worth it.