Review on 🔧 Enhance Your Wheel's Performance with the Milton S-466 Tire Valve Adapter Kit by Chris Mania

I ordered a larger block but it didn't fit the valve stems on my discs. It has two adapters. One fits my valve stems. Then all that was left was to fill the tires with water. The first hoop was trial and error. After that, the rest filled up easily. You really need a check valve on the end of the water hose and a valve stem tool to make this job easier. My procedure: 1) Lift the tire off the ground. 2) Rotate the stem to the top of the bar. 3) Remove the valve stem. ) Allow the tire to fully deflate. 5) Connect the adapter to the tire valve stem. 6) Connect the hose to the adapter. 7) Turn on the water. 8) Apply water until it stops or slows down. 9) Turn off the water. 10) Press the button on the air outlet adapter. 11) Repeat steps 7-10 until only water comes out of the adapter when you press the button, not a mixture of air and water. 12) Prepare the valve stem for insertion. 13) Remove the adapter from the valve as soon as possible. You can then place your finger or thumb on the valve to prevent water leakage. 14) Install the valve stem. 15) Inflate the tire to normal pressure with air. You should hear a gurgling sound as the air is forced in. If you don't do this you will have to add more water or the discs may rust, so go back to step 3 and repeat the process. Note: you will get wet.