Review on 🔧 Mastering Print Quality: Monoprice Resolution Printer Leveling & Curing Solution by Shawn Reiter

I'm relatively new to the resin printer, but I have too another inexpensive resin printer that I've had much better success with. I bought it because I wanted to see how much better it would be to have auto-orientation. Most of my prints with the Monoprice MP Mini SLA fail in one way or another, from misprints to complete failure. The only things I can successfully print are very small items e.g. B. 20 mm cube or smaller. The software sucks, and like the others, you'll probably just turn off the Wi-Fi feature. Don't trust him at all to give you enough support. I've trusted the brand to be reasonably decent here, but I definitely feel like I've bought an unnamed piece of junk that will only cost me more time and materials than it's worth. Edit: Absolutely the worst! I realized that my misprints were the result of improper exposure of the print area. I tried replacing the FEP film just to be sure, but it was impossible to stretch the film due to the way you have to do it. I did something wrong, who knows, there are zero instructions on the network. It was only mentioned that at some point in the future it will be possible to buy the entire tank assembly. Switching FEPs is always tedious, I know that, but not only was it tedious, it was a terrible design that doomed you. This machine should not be sold under this brand or at all.