Review on Enhance Precision in Framing Carpentry with Mr Carpenter Square Framing Carpenters by Christopher Buck
Numbers are erased, inches/cm on opposite sides, thick and strong
Ruler is thick and strong as far as I can tell, but 90 degrees. inches/centimeters on the opposite (left)/rectangular side), so if you want to measure 10cm to the left and then 10cm to the right, you _cannot_ . b/c says "3.9" on one side instead. Also, I had significant wear on the numerals/measurement marks which I have little use for at home for crafting/sewing. I don't have any major suggestions for fixing the right-left problem, but it would be much better if the numbers were engraved rather than silk-screened.
- Lots of positive emotions
- No power
New products
Comments (0)
Top products in 📏 Dimensional Measurement
Laser rangefinder Xiaomi ATuMan Duka LS-P Laser Range Finder 40 m gray
119 Review
Laser level Zitrek LL1V1H
36 Review
Thickness gauge CarSys DPM-816 PRO (Fe/nFe)
31 Review
Cullaby Contour Gauge: 10 & 5 Inch Duplications For Perfect Templates Of Curved And Odd Shapes, Plus Bonus Angle Ruler & Carpenter Pen!
23 Review
Another interesting products
🔍 Enhanced Precision with Backlit Professional Manometer for Differential Ventilation
6 Review
🔍 Dioxide Controller for Digital Gas Monitoring
5 Review
🌬️ Advanced 3-in-1 Indoor Air Quality Monitor with CO2/RH/Temp Data Logging and Audible Alarm - NDIR Sensor Technology
8 Review
Digital multimeter RGK DM-12
6 Review