Review on 🔑 Enhanced KeylessEntry Remote Control Key Fob Replacement - HYQ1512V Compatible by Dusty Oner

This fits my GS300 well but the instructions that came with it are not for remote and token programming. Instead, follow these instructions on the Clublexus website: REMOTE PROGRAMMING: 1. Close and lock all doors. Unlock and open the driver's door.2. Insert and remove the key from the ignition switch. Not include.3. With electric lock switch. Lock and unlock 5 times. (Lock, unlock, lock, unlock, lock, unlock, lock, unlock, lock, unlock)4. Close and open driver's door.5. With electric lock switch. Lock and unlock 5 times. (Lock, unlock, lock, unlock, lock, unlock, lock, unlock, lock, unlock) 6. Insert the key into the ignition switch. Turn "ON", turn off and erase.7. You will see that the door locks switch by themselves. If the door locks do not switch (lock and unlock) by themselves, the vehicle is not in programming mode and you will have to start over.8. Simultaneously press and hold the LOCK and UNLOCK buttons on the remote control for no more than 2 seconds.9. Press the LOCK button on the remote control for less than 1 second. AT THIS MOMENT the locks should ONCE work by themselves. The procedure is thus accepted. If the locks work twice, it fails. The most common reason for a programming error is that the car didn't get a good signal from the remote control. Try these tips to fix this problem. 1) Stand outside the vehicle while performing steps 8 and 9. 2) Do not hold down the buttons on the remote control while the vehicle is in programming mode. You can continue with steps 8 and 9 until programming is complete. If you wait too long and the vehicle exits programming mode, you will have to start over. After you have received your programming remote, proceed to step 10.10. Close and open the door to complete the programming process.1. Insert the already programmed master key into the ignition switch. Don't turn.2. Press and release the accelerator pedal 5 times.3. Press and release the brake pedal 6 times.4. Remove the key from the ignition switch.5. Insert the new key you want to program into the ignition.6. Press and release the accelerator once.7. wait 1 minute The security light will flash for that minute. When it stops flashing, your key is programmed. To complete programming, press the brake once. A NOTICE. Watch out for the security indicator. This light guides you through the programming process. The security light will turn off in step 1. It stays off until step 6. The security light will turn on and flash after step 6 until the key is programmed. If the security light comes on after step 4, STOP the process and start again. If you follow this procedure too slowly, your vehicle will not enter programming mode. If you cannot put your vehicle into programming mode, make sure you are using the master key and not the parking key. If you have a master key, you'll likely need to complete this process more quickly. Read more here: [.]