Review on 🔥 Firestone Spring Spacer Kit WR17602366 - 2 inch, Silver by Fredo Zhan

I installed them on my Air Lift Bags. These work with airlift bags, you need to buy some screws, see below. I was told by 4Wheel Parts that I need a 6" spacer because of my 6" lift but that is incorrect. It is important that the distance between the top and bottom mounting brackets is within specification. Specifications for Ride Rite and Airlift Bags can be found on their websites. For my application, the airbag should move 6 inches with no additional load. After installation I was at 7.75 inches. This will reduce the movement of your airbag before it expands too much and eventually rips the panels out of the airbag. I said this kit is suitable for pneumatic bags. However, you must: 1. Replace the 4 3/8-16 hex head screws that come with these gaskets with 3/8-24 hex head screws. Threaded, Ride Rite airbags are threaded. Bolt. The inserts on the Firestone shock absorber are threaded. I had to keep the pan head screw because the bracket that rests on the pivot plate pivots and in the installed position sits over one of those screws. heads. These screws are not expensive. The instructions also say to align the seal with the sticker towards the back of the truck. j. There is no sticker on it. A google search led me to an e-trailer site and the question was answered there: There is no sticker for a two inch spacer and the orientation of the spacer is not critical. Just make sure you use the correct mounting holes to mount the bottom bracket to the airbag so that it is in the correct alignment with the top bracket. existing airbag. Enough space. It's just tight. Don't forget to use screw lock. Installation was easy. Another tip: don't forget to deflate your airbags (if they're already set at 5psi). I have a Firestone F3 Wireless Air System. Then use an 8mm wrench to press the air duct into an interference fit. It will appear without violence, allowing you to complete the installation.