Easy install except I need terminators on my 2008 JKU Rubicon. Disconnect the wiring, remove the bulb from the existing turn signal and press the notch on the two tabs and slide the existing turn signal through the front of the grille. You may have to press and squeeze the tab on one second and then press for a little while while continuing to pressurize the signal. That was the easy part. Not a lot of room for wiring, but more if you turn the wheel to make room. The pull up resistor goes from the black wire to the white wire closest to the red slide on the harness. You can check that with a simple 12V tester. Turn on the turn signal you want to test and touch the wire harness on that wire and the test should cycle on and off. I mounted the terminator to the frame by drilling the small hole you see in the photo and simply screwing it on.
🔦 High-Performance LED License Plate Trailer Light: Bracket Mount, DOT FMVSS 108 Compliant, SAE L Certified, Gray-Finish, Waterproof, 12V DC - Ideal for UTV, ATV, Trailer, Truck, RV, and Boat
5 Review
AmeriLite Replacement Lights Silverado Harness
8 Review
🌊 Waterproof Warranty Grommets by Nilight TL 01
6 Review
🚗 ZMAUTOPARTS Smoked Tail Brake Lights for 1999-2006 Chevy Silverado/GMC Sierra Pickup
5 Review
LEDKINGDOMUS 44Mm Festoon LED Bulb, Bright White Interior Light For Car Dome Map, 12 SMD 3528 Chips, Rigid Loop, Compatible With 561 562 567 564, Pack Of 4
36 Review
Upgrade Your Headlights With H1 LED Bulbs: 8 Sides CSP Chips, Super Bright White 6000K And 12000LM For High/Low Beam And Fog Lights - Get 360 Degree Lighting
40 Review
BRISHINE 300LM Canbus Error Free T10 LED Bulbs - Pack Of 4 Extremely Bright 194 168 2825 W5W, 6000K Xenon White, 9-SMD 2835 LED Chipsets For Dome, Map, Door, Courtesy, And License Plate Lights
43 Review
12 Pack - WEIMELTOY Red LED Car Bulb 194 With 3030 Chipset & 2 SMD T10/168/W5W Wedge Light Bulbs, 1.5W 12V For License Plate, Courtesy, Step & Trunk Lamps, Clearance Lights
36 Review