Just what I needed for the fill hole on my 40 gallon auxiliary tank for my air compressor. I built an external auxiliary air tank out of an old gas water heater tank to use as an additional external tank for my 4hp air compressor. I installed a tank with a regulator, dryer, lubricator, safety valve, tank gauge and regulator gauge, drain valve to drain the water and fill the hole. I used a small manual valve that soon became a PITA and had to remember to open and close it when filling. My old original tank on the compressor was leaking so I wanted to be able to shut off the extra tank so it wouldn't leak back through the leaking original tank. So I decided on this check valve to replace the manual fill valve. Works very well and fast enough to fill a 40 gallon auxiliary tank. Topped up from zero to 110psi in about 5 minutes so that's enough for me. Seems to be holding up well so far. Seems well done.
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review