Header banner
Revain logoHome Page
Paul Williams photo
1 Level
1278 Review
45 Karma

Review on πŸ”₯ High Temperature 3D Printer T-K500 m3 x 15mm K Type Thermocouple Sensor - Compatible with Volcano V6 HOTEND Block for 500℃ PEI PEEK 3D Printing by Paul Williams

Revainrating 5 out of 5

Good quality but be careful full stainless steel mesh

I give 5 stars for the price and quality. I've been using this thermocouple for a while and it's reliable. And the stainless steel mesh feels comfortable. But my extruder has a connector on the carriage with a separate wire harness that runs between the carriage and the control board, so the entire length of this braided wire is looped tightly and attached to my hot end, since the stainless steel sleeve doesn't make length changes in a serious attempt. . I can't dock a product for this, but I'm not sure a stainless steel braid the full length of the wire is a huge feature. Stainless steel for the first 5cm or something might be more efficient.

Pros
  • Temperature and humidity
Cons
  • I will add later