These are not very strong fasteners and will break in half with strong resistance with very little torque. To avoid this, a properly sized hole is required, which at a 5/16" size corresponds to a 1/4" diameter hole (3/8" anchors require a 3/8" hole, so the anchor type is slightly different ). Second, you must drill the hole at least 3/4 inch deeper than the length of the Tapson anchor and use a feeler gauge to verify the exact depth. Third, you need to use an air compressor to blow the mud out of the hole and process the compressed air. even better since you can insert the small diameter plastic tube into the hole and blow it all out. If you don't follow these steps, you may find that half of the Tapcon anchor is stuck in the hole, turning one project into two.
SZHKM 150PCS M6 Kit Crib Screws Hardware Replacement Kit Hex Socket Head Cap Screws Nuts Zinc Plated M6 Screws Barrel Screws Furniture Screws And Bolts Assortment Kit For Baby Bed With Free Tools
24 Review
Hankook Tire Ventus Prime3 K125 195/55 R15 89V summer
12 Review
Universal JONNESWAY S04H52494S, 94 pcs, green
11 Review
π© Included Fastener for Drywall - TOGGLER SNAPTOGGLE
10 Review