Installed 4 days ago and so far so good, message "Tighten tank cap" is gone. I noticed that the Denso sensor I received was made in Japan and not the sensor I removed which was made in Mexico. Quick tip: you will need to reuse the metal washer and nut that originally attached the sensor to the manifold. So be careful not to drop them. One of the air hoses (which connects to the top of the sensor) got stuck so I pushed it back a little with a flat head, used WD40 and left it on a little to try to get in so it's easier to pull off, penetrating oil is probably best, but I didn't have any available. Good luck, I hope my review was helpful.
🔋 DB Electrical SBS0001 Starter Briggs: Reliable Starting Power for Your Briggs Engine
9 Review
Zento Deals 8 Pieces of 6 Ohm 50W Load Resistors – Eliminate Flickering LED Turn Signal Lights, License Plate Lights, and DRL
9 Review
Electrical AFD0097 3F1U 10300 AA 3F1Z 10346 AB VP3F1U 10300 AA
10 Review
⚡️ Powermaster 9600 Str Master Infi-Clock: Chevy Universal Straight Mtg 153/168T Flyw 14:1 Black Wrinkle - Supercharged Performance Ignition System
10 Review