Review on π Secure Your HVAC System with VIVOSUN Stainless Steel Duct Clamps by Matt Watson
USE THIS TO HOLD MY AMERICAN FLAG ON A WOODEN POST
Originally used 6" long, 3/16" bolts with washers and nylon nuts to hold the flagpole bracket in place. After 6 years it started to loosen so I used this clip along with 3/4" aluminum corners (about 1" long) which prevent the clip from squeezing the wooden corners of the pole and holding the flag mount in place. So far so good, even with wind speeds of 30-40 m/s.
- Multiple uses, easy to install.
- Cord is shorter than other picks
New products
Comments (0)
Top products in π§ Fittings
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
Vacuum cleaner Dreame V9 Global, white
145 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
