As an electrical engineer, I was looking for a quick and easy way to connect pins for development. They're great for layout work, but not much more in my opinion. As far as the pins connect for the prototype, they work fine, but often fall apart due to loose connections. The heads also come off easily, causing many of them to break as well. Fine for a small project, but as far as daisy chains and permanent connections go, I'd suggest a wire wrap or other connector.
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
๐ MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
๐ Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review
๐ฅ๏ธ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
MacBook Retina 13-inch (A1425, A1502) and ๐ฉ 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review