Review on Sena ES0003001 Smh10 Clamp Helmets by Cornelius Mosley
Not a very good design, still lots of wind noise
It works and does what it's supposed to, but the fit isn't as good as advertised. I was expecting it to be tight, but heck it's a struggle to put SENA on a helmet. I have to use 20-30 pounds of pressure to connect the device to this mount. This is a combination of a Bell helmet and binding. I will not buy these helmets again. It doesn't matter because the wind noise is just as bad as the standard mount on my other helmet.
- Weight
- Protection
New products
Comments (0)
Top products in 👨💻 Powersports Electronics
Stay Secured With 9 Multi Outlets Surge Protector Power Strip And 5Ft Extension Cord For Home And Office Needs
22 Review
Upgrade Your Sound With InstallGear Dual 8 Gauge Amp Wiring Kit Featuring True Spec Soft Touch Wire - Ideal For Amplifier And Subwoofer Installation With 8 Gauge Wire.
46 Review
Hankook Tire Dynapro HP2 RA33 265/65 R17 112H summer
18 Review
🔌 ECHOGEAR Rotating Outlet Surge Protector 2-Pack: 8 Outlets, Flat Plug, Long Cord, Mounting Holes - Black
26 Review
Another interesting products
🎧 FARO Aviation Headset Converter: Low to High Impedance Adapter for General Aviation (GA) and Military Headsets
9 Review
🛩️ Stratux ADS-B Dual Band Receiver: Advanced Aviation Weather and Traffic System with WAAS GPS, AHRS, Battery Pack, Suction Mount, Antennas, SDR
9 Review
✈️ Enhancing Aviation Safety: ASA-OVC View Limiting Device for Clearer Vision in Overcast Conditions
9 Review
🎧 Alpha Pilot Headset Flight Bag (Black) – Streamlined Flyer Solution
8 Review