Review on Sunco Lighting 120 277V Connector Included Lighting & Ceiling Fans for Ceiling Lights by Crystal Drake

I need to remodel an old 1970's lake house. Lots of crappy lighting fixtures - spheres, spotlights, power rails - so I needed a quick light replacement AND something that would allow me to switch to LED in the meantime. These 4 inch Sunco LED can housings turned out to be PERFECT for my job. I chose the 4" size because most (if not all) of my ceiling light j-boxes have 4" holes. J-Box aside (it's the only "heavy" part and it's not that bad.) I just had to widen the hole in the ceiling a bit. I disassembled one of the Sunco cases so I can only use part of the glass to fit the hole. When the hole is complete, simply select the knockout position, insert an appropriate wire clip, feed the wires through and insert into these cool little WAGO type wire nuts. They offered... Very easy! I found it easier to leave the small glass clips on while setting everything in place. Make sure you have a gap if you're in any kind of isolation. The clamps are already tight and difficult to snap into place if something gets under them. I chose Sunco 4" LED lights for these cases. They plug and play into the bench and go straight to work. Turn on the AC and admire your work! The photo shows a very sketchy headlight , which was carefully replaced in about 30 minutes. And I'm kinda old and slow! So here you have it! I'll buy more! You should check them out too!