Review on Ducati 1299 Panigale Fender Eliminator by Eric Rios

This stylish tail set looks fantastic after installation. As I said, there are no instructions for it. Therefore, I will give you a brief overview of the installation and the license holder. Remove the rear seat (or hood). Remove the 4 hex bolts from the 4 corners under the seat. You don't need to take anything out of the OEM tail except four under the seat. Use alcohol to clean the underside of the taillights where the kit will be installed. Secure the wires in a neat tail knot, making sure they are connected properly. Remove the protective film from the adhesive backing and place the kit where it belongs. Use the included bolt, washer and locknut to attach it to the transom by going through the eyelet hole in the center of the storage compartment. There are other wires that use this so be careful not to damage them when tightening the jam nut. The license plate bracket has an L-shaped bracket that is included. If you plan to leave the passenger footpegs on the bike, use the factory hex head screws to attach the plate and bracket. When you have removed the pins. Use the screws provided. There is a video on YouTube on how to install it if you get stuck. But in general it's pretty simple. Be careful with the long screw and wire and slide the license plate bracket between the footpegs and the rear of the bike.