Review on Dorman 923-202 Center High Mount Third Brake Light for Ford and Mercury Models by Dusty Tofte

Perfect fit, minimal instructions. I'll note a few things for others involved in the exchange. First, take a small metal stick with protrusions from the OLD. This matches the row of pins on the new one. Once installed, it hooks onto the folded edge of the pad and holds one side. Second. The plug is already at the end and does not fit through the existing hole. It can be removed so you can thread the two male ends and reattach the connector. Be sure to mark the polarity (on the plug) before removing the plug. Third, I used a hand riveting tool and seven 1/8" x 1/8" aluminum rivets for the seven rivets you need to drill out. Charm works. Screws are used in the online video. You can get a small rivet set from Home Depot, Lowes etc, it comes with rivets and hand tools, not very expensive. Hey, Ford used rivets, why not? Additional Notes: Doesn't seem too bright in daylight but could be from around the corner. Like most LED products, it cannot be seen too far from the side. The landing was otherwise quite good and fairly quick - I got about an hour after watching some videos on this part.