Review on 📱 6 Pack LϟK Apple Watch Screen Protector 40mm SE/Series 6/Series 5 - Maximum Coverage, Bubble-Free, Flexible TPU Film for HD Clear Screen Protection by Scott Larson

This screensaver looks like it will perfectly protect my Apple SE. I also installed a clip guard for extra protection and they work great together. I had no trouble applying it (it worked the first time) and after a couple of weeks the edges were holding up well. In fact, one of the clip protectors I bought snaps onto the edge of this headband when I take it off and it cuts off the edge of the film a bit and the edges don't tear it off. This is about as good as an adhesion test you will get. I have 4 tips: 1- The installation video url provided with the product is a dead link. Just look for the specified URL in your browser. The current link appears immediately in the results. 2-Do not remove the bracelet from the watch. This is not necessary and you lose the only way to keep the watch safe. Next time I'll use non-permanent masking tape for the finish and tape both sides of the tape to the table to secure the clock to the mounting stand provided. I have no idea why they tell you to remove the strap. 3-Clean the entire watch face with an alcohol wipe, including all edges of the screen and the entire perimeter of the bezel. I think some of the "peeling edges" issues may be due to the entire surface not being properly cleaned. The film wraps down and around the screen instead of just sitting on it. prompts you to press down on all edges of the slide. There is a special process of "pulling in opposite directions". Because of the "Clear Edges" comments here, I've spent a lot of time on this. I then rubbed the film several times with a cleaning cloth, pressed it and was particularly careful to press the edges again and again. I am very satisfied with this product. And I have 5 spare films.