Review on BCZAMD Dual-Textured Spring Powder by Alvaro Delic

Update: Had to buy a new one after four months. Print PC blends without a glue stick. Bad idea. Whole parts of the coating were torn out during removal. You can't blame the paper for that. Prusa emphasizes that PC Blend requires a glue stick, and it even comes with the filament. i was just stupid Immediately ordered two more of these - they are fantastic. Update after a month of use: Super. It has been used almost 24x7 and it works great. I don't see any signs of degradation. The only downside so far is that small lines of PETG (e.g. the base layer of supports) may stick too well and be difficult to remove. I used a spatula to remove them and the leaf seems to be taking it well. Very happy. I had endless hours of grief with the textured sheet sold by Prusa. I eventually got over it and got great prints with PETG but still had occasional crashes with PLA. So I decided to try this option. I've only been working with him for about a week, but so far I'm very impressed. PLA holds up great. PETG, no problem. Haven't tried ABS yet, but I'm sure it will work too. The surface is much rougher than Prusa disks. Maybe that's why it works better. To be honest I prefer the surface finish of the Prusa texture sheet, but again it's no good if the PLA doesn't stick. So I am very satisfied with this product.