Review on KOOTANS Brass Coupler Fitting Quick Connect by Sean Davis
The threaded part is too short.
Threaded section short, end too large. I had to tap the thread deeper to be shallow enough to start my hardware cutting into the hex. I used one on my welder for gas supply. The threaded section should be 1/8" longer so it's smaller and has enough taper to fit properly.
- Hydraulic, Pneumatic and Plumbing
- No Power
New products
Comments (0)
Top products in π§ Fittings
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
