Review on 🔪 Maximize Cutting Efficiency: EZARC Oscillating Tool Blades with Carbide for Hard Material, Metal, Nails, Bolts, Screws - 3-Pack by Ashwin Chauhan

I bought this because I need to cut out a rusty sway bar. Space was too tight for a 4.5 wheel and I felt the Dremel wheel was too slow for the job. I used to use a soft metal blade for half inch screws and it was slow and I broke one blade per screw. So I figured this must be the right blade for the job. Arrived today, took the big chuck off the stabilizer bar with a grinding wheel and started using it for the rest. I was relatively happy at first because the blade didn't wear out that quickly, but it didn't cut much either. I've read the reviews and I've strictly followed the advice of not putting too much strain on it and just letting the blade do its job. No, it does not work. In fact, I barely squeezed it and stopped cutting every 10-30 seconds for fear the blade might get hot. Took me about 15 minutes. To cut about halfway through a .5" screw, I found that the center of the blade's teeth were gone! Yes, I'm 100% sure I didn't put any pressure on him. It's even worse than my set of soft metal bladed multi-tools. I would cut the screw in 20 minutes. when I used the blade kit. In fact, it's a lot worse than a Dremel cutting wheel. I ended up cutting off the side of the nut using a cutter wheel and then a small cutter wheel, which took 15 minutes. I'm completely amazed why there are so many good reviews that this thing can cut 10 1/2 screws without wearing blades. It just doesn't work. I'll upload the picture later.