piston seal has high friction. Once it starts moving it's free, but it takes a little effort to break the o-ring and get it moving. It is difficult to achieve smooth action. The pressure builds up and nothing happens, then it goes on quickly. There will be no problem if higher pressure is applied to the piston (50+ psi is great), but if you're trying to run at low pressure for low forces, friction comes into play. If you want smooth performance at 5-10 psi, this isn't for you. The quality is good for the price. Not junk, just not the best choice for low pressure. I'll keep it to myself, I'm sure I'll find a use for it later.
🔧 Parker 2 00DXPSR06 0 Stainless Cylinder Non Cushioned - Optimal Performance and Durability
3 Review
⚡️ Efficient Insulated U Type Connector Electrical Terminal for Optimal Electrical Connections
8 Review
Baomain Pneumatic Air Cylinder Bore
4 Review
🔧 Tailonz 8Ft Nylon Pneumatic Tube - 32 Diameter
4 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review