Review on 🚗 Kia Stinger 17~18 Emblem and Wheel Cap Set: Genuine OEM Front, Rear, and Center (6 pcs) by Adam Quintana

Genuine OEM Parts. I feel like there are general questions and the answers are like a reddit keyboard warrior who knows everything. Long story short: 1 Center Caps - the 'upper' arm (on normal Kia orientation) has a small cut out - remove these by hand. it is much easier. 2 Back Badges - I used a heat gun and string to trim the edges of the double sided tape/glue. Be careful and place some masking tape under the edges of the badge and then use a non-marking tool to lift and remove. Peel off the glue, fill in the holes (silicone is easy), then line up the foam frame with the holes behind N and G. The foam will sag a bit, so focus on centering and evenly distributing the "lead" around the tip. Clean the logo and SLOWLY press it into the 3 front badges - this one was MUCH harder to remove but use the same method as above. I used pliers and quickly squeezed and twisted the bottom bolt. You can cut with a razor to get it under the tape/glue line. peel and stick.