Review on 🔍 Black Non-security Peerless ST670P Tilt Wall Mount for 46 Inch to 90 Inch Displays - Optimize your search by Janet Bartling

The ST670P I received was released in January 2010. I would like to thank everyone who has commented on this. You really helped me get this awesome wall mount! It has a ratchet adjustment knob so you can adjust it while it's leaning against the wall. I loosened mine as loosely as possible and then attached it to the wall. Customization was very easy. Then I increased the tension with a ratchet. My comments on other comments are as follows: [D. Spain "Philoguy"] Cannot loosen the adjustment knob when standing against a wall. [Mine] has a ratchet handle to adjust the tilt force. [Flyboy2610] and [UBHappy] Loosen the hex screw to adjust. [Mine] and [Talent Relations "TR"] were difficult to set up when not on the wall. [L block] and I used a screwdriver as a pry bar to feel the adjustment (with very light tension). [Flyboy2610] Security screws are difficult to access. I had the same problem, but with a 2 foot Phillips screwdriver and a flashlight everything went smoothly. [Talent Relations "TR"] Round the handles. [Mine] has a ratchet handle. You pull it out to loosen it and push it in to adjust. [D Wooten] Directions are almost useless. [Mine] I had to keep reading, but finally I was able to follow them. [1gringoframLA]Knobs get in the way of tuning. [Mine] has a ratchet handle. You pull it out to loosen it and push it in to adjust. Bottom pin removed. (Removing this pin reduces the range of tilt and changes the weight it can support.) [Mine] and [Talent Ratio "TR"] were difficult to adjust when not on the wall. [L block] and I used a screwdriver as a pry bar to feel the adjustment (with very light tension).